If you have view my earlier posting on how to make a blowgun (Simple instructions to make a blowgun), here is an actual product from the short instructional video. For just RM6.45, I got myself a 6 feet 6 inches 1/2 inch pvc conduit which I got the shop to cut into two equal halves as well as two reducer for the mouthpiece.
Here the mouthpieces are attached to the end of the roughest surface of the time. No glue needed as it is tight enough just from the friction. At this stage, you need to make sure the pipes are relatively straight. If it is not, slowly bending it will make the pipe straighter.
To make the dart is easy. Paper cone and a sharp point is all that is needed to make a straight-flying dart. If you don't have hot glue, just use tape to keep in all together. Below is a dart made out of toothpick.
Here is a dart made out of 2 inch nails.
Here is a dart made out of a screw.
Here the mouthpieces are attached to the end of the roughest surface of the time. No glue needed as it is tight enough just from the friction. At this stage, you need to make sure the pipes are relatively straight. If it is not, slowly bending it will make the pipe straighter.
To make the dart is easy. Paper cone and a sharp point is all that is needed to make a straight-flying dart. If you don't have hot glue, just use tape to keep in all together. Below is a dart made out of toothpick.
Here is a dart made out of 2 inch nails.
Here is a dart made out of a screw.
No comments:
Post a Comment